i2R UCCNC Spindle ON / OFF Operation (Quick Tip)

This is a quick HOW TO on operating your VFD controlled spindle using the UCCNC interface with the MDI field. 24,000 RPM is the max rate on the spindle. We never cut anything with the spindle less than 16,000 rpm even though the spindle can get as low as 12,000 RPM.


Leave a comment

Please note, comments must be approved before they are published

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.


You may also like

View all
Example blog post
Example blog post
Example blog post